Broken windows of the huge workshops of abandoned enterprises frighten the few passers-by, piles of rusting metal rise in the backyards... These high-tech ruins can tell us a lot about the enterprises of a bygone era.
It is the result of strict calculation of optimal costs of all resources, competent utilization of waste and strict control over the impact of certain production processes on the environmental situation in the region. Scrap metal dumps, which often adorned the backyards of Soviet factories, will not be found at a modern enterprise. Scrap metal, if its processing, of course, is not the main profile of the enterprise, is stored in neat briquettes, suitable for further transportation and melting into metal products. A special machine - press shears - helps to achieve this result.
Depending on the profile of the enterprise and, as a consequence, the volume of scrap metal to be processed, a particular model of the unit is selected. The model range of press shears, presented by domestic and foreign manufacturers, is so wide that it allows you to choose a unit with the characteristics required for the needs of virtually any enterprise. (It is logical to assume that a small confectionery shop, where metal recycling is quite rare, needs a less powerful model than a metal pipe casting plant, where scrap metal recycling is an integral element of the production chain).
The economic advantages of the secondary use of scrap metal at a metal processing plant are obvious: due to the melting of primary metal processing waste, the amount of raw materials and, consequently, the amount of final products increases significantly, thanks to the sale of which the company's profit grows.
Hydraulic press for scrap metal at such an enterprise is an indispensable element of the production cycle, allowing to rationalize the production line, reduce the costs of both primary raw materials and labor resources. Permanent utilization of metal waste (which, given the profile of the activity of the enterprise in question, accumulates a lot) in the presence of press shears in the production not only does not cause additional difficulties, but also brings tangible profits.
The estimated profit margins vary depending on the volume of metal processed, the type and manufacturer of the chosen machine. However, regardless of the estimated capacity and other technical characteristics of the unit and its cost, it is hard to imagine a modern metalworking enterprise without a scrap metal press. The efficiency of the entire production line directly depends on its effectiveness. Turning waste and technological debris into raw materials is not just saving money and materials, it is modern efficient use of resources. It is a reduction in labor and logistics costs (due to the reduced volume of metal after pressing it into briquettes, transport will be able to bring more, using the same amount of fuel and time on the road), it is quality control of raw materials at the processing stage.
Rationalize your production with press shears from Baltapress - forget about the fact that scrap metal can be a problem.
Comments0